Nitecore Battery Bank Cap for Gen 1
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A cap for the original version of the Nitecore NB10000 battery banks to prevent accidental button presses.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 298
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The Nitecore power banks have a bug where if you press and hold the power button they enter a lockout/hibernation mode. The mode can only be cleared by charging the power bank, which is not possible if this is your only power source, although I have heard you can get them out of the hibernation mode by charging with another power bank.
@BenFriesen_571729 worked out a great design to for the Gen 2 power bank. The Gen 1 has the power button in a different place. I reworked his design to accommodate that. This design fully covers the power button and has a recess so that it can't possibly be pressed. It's also slightly tighter than the original, but, since the dimensions on the power banks vary a little, you still may have to play with the scaling a bit to get a perfect fit.
Weighs less than 2g. Print with PETG. With parts that have a narrow wall like this, I like to set the outer perimeter wider than the wall, e.g. 1mm, so that it prints as a single perimeter, but standard PETG settings should work just as well.
Thanks Ben for the great design.