Remix of the motherboard cover by Henlor for 120mm fan
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I decided that a 60mm fan was still too noisy, so I adapted both the motherboard base and cover to fit a 120mm fan
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 313
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I basically modified the motherboard base and cover to be fixed using m3 nuts and screws instead of magnets and created a mounting plate on top to fit a 120mm fan for those that run the printer without the metal plate underneath. Mind you should still put a filter on the fan so it doesn't suck up dirt onto the motherboard.
I'm using a Nocuta NF-A12x25 Chromax and a noctua NA-VC1 24-12V stepdown adapter
just print both and where the magnets would go, you use an M3 screw (I used a M3x16, but that's what I had at hand at the time.
PS: The picture is of the first iteration, but I was not happy with the quality. The uploaded file is the correct one.
