1 / 7
Twisty; A 3D Printed mechanical pencil
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Have the lead but not the pencil? Short on pencils? Want a special pencil? Well this model is for you.
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 94
- Wydruki
- 0
- Wyświetlenia
- 929
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Art & Designs
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (6)Wydruki i komentarze (Wydruki: 0) (Komentarze: 1)Remiksy (0)Kolekcje (20)Powiązane
- Uses 0.7mm lead
- Just twist the screw to advance the lead
- The screw prints in 2 parts, and you should glue them together. You can also try to melt/solder the pieces together.
- Print the screw with 100% infill for best strength
- If the hole for the lead in the body is too small, you can use a small pin or a needle to make it bigger.
- It is recommended to print it slowly since there are fine parts and no supports are needed
- Please let me know if anything doesn't fit
- Designed by me in Tinkercad
- FYI: I soldered/melted the 2 pieces together in the photo, but it isn't required, you can just use glue, or it may friction fit.