1 / 3
Electric skateboard slim enclosure with gasket — zdjęcie 1
1 / 3

Electric skateboard slim enclosure with gasket

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This case is for relatively slim builds that can be printed either in full or in parts.

Ocena
0 / 5
Polubienia
3
Pobrania
23
Wydruki
0
Wyświetlenia
156
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

  I needed a relatively slim case for my new skate so i started from scratch. 

 Step files included if you need to adjust some values for holes, deck curve etc.

  My build uses 10s2p 21700 Li-ion, cheap chinese esc, charge indicator (20.4mm x 31.4mm), power button (12mm) and charging port (12mm). Your deck should be 200mm wide. Mine is also almost flat.

  To assemble everything you need 8 45mm length 5mm screws (or longer depending on your deck thickness) and 8 nuts. Just insert nuts in hexagonal holes and with screws it will provide needed strength. I would also recommend to mark holes before drilling a deck.
 

  You can print either of 3 models depending on your build platform:

  First one is full model enclosure and gasket (requires 400mm bed platform). I have neptune 3 plus so I was unable to print it.

  Second one is a split model to use on smaller printers (requires 200mm bed platform). enclosure parts should be printed vertically with no support (providing you are ok with bridges and overhangs that your printers makes, otherwise i suggest using tree supports in some areas). The model is designed so that the screws not only connect case to a deck but hold all parts together. Additionaly i would suggest using epoxy glue to seal the seams (tried this version as my test print, after epoxy it was watertight).
  TPU gasket is split in the middle and can be bonded by using soldering iron. Just melt it along the seam and it will be good to go (tested it myself.)

Third version is for those who has 300"ish"mm platform like me. Make sure your z axis also allows for at least 300mm prints (can be slightly adjusted). This variant is angled so you can fit it on your platform. to ensure the case won't fall during printing i added a "fin" that has small attachment point along the back of the enclosure (breaks off easily). Make sure using large brims so everything doesn't fall off. (I used this model, see in pics).

PETG and TPU are better choice for this. But i guess you could use ABS, ASA, tough PLA or PLA+. But i strongly advice against regular PLA. 

Settings I used:

0.2 layer height

3 external perimeters;

20% gyroid infill;

 6 top and bottom layers;

brim (at least 8 loops).

The rest is up tou you. 

 

Tagi