1 / 3
Infimech TX aux blower fan V2 - with hepa filter — zdjęcie 1
1 / 3

Infimech TX aux blower fan V2 - with hepa filter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Uses same fan and duct as V1. Adds better housing and hepa filter

Ocena
0 / 5
Polubienia
12
Pobrania
36
Wydruki
0
Wyświetlenia
677
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Full housing for 120mm fan and adds the ability to have a HEPA recirculation filter. Takes GL-2103 filters like these.  can be run as aux blower, aux blower with HEPA, or just HEPA recirculation with fan duct removed. I am told the duct will print without supports ymmv

Instructions

Press 3 x m3 heatsets into 3 outer holes on fan body

assemble housing

place fan in housing face down and slide back on

Put one short m2 pan head bolt in bottom right corner and loosely put 15mm-ish bolts on other 2 corners to locate

Remove 2 long bolts and use them to bolt to back of machine

Install HEPA filter as needed