KM4CFT CFT1 Transceiver Cover - v1 and v2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The perfect cover and angled stand to go with my custom CFT1 Case
- Ocena
- 5 / 5
- Polubienia
- 7
- Pobrania
- 48
- Wydruki
- 1
- Wyświetlenia
- 386
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Now with CFT1 v2 compatibility.
Print this magnetic cover to protect your CFT1, and provide the perfect stand for table-top operation. Rubber pads on four points provide stable, grippy security for your rig as you operate.
Use 2 colors of PETG to match your custom CFT1 case.
PRINTING:
For best results, I recommend printing with 2 outer perimeters, 4 top/bottom layers, and 25% infill. Decent bridging performance is needed for the ~25mm bridges. PETG strongly recommended for outdoor/in-vehicle temperature stability.
Hardware needed (Amazon affiliate links):
10x2mm magnets: https://amzn.to/4eaHLRV
10mm Rubber Pads: https://amzn.to/3z4CSeq
The attached gcode is set up for two color changes and a pause for magnet insertion. These occur about 45 minutes in and occur on consecutive layers.
Layer 15: Color change
Layer 16: Pause to insert magnets
Layer 17: Color change
Enjoy!