KM4CFT CFT1 Transceiver Cover - v1 and v2
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
The perfect cover and angled stand to go with my custom CFT1 Case
- Rating
- 5 / 5
- Likes
- 7
- Downloads
- 48
- Makes
- 1
- Views
- 386
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Now with CFT1 v2 compatibility.
Print this magnetic cover to protect your CFT1, and provide the perfect stand for table-top operation. Rubber pads on four points provide stable, grippy security for your rig as you operate.
Use 2 colors of PETG to match your custom CFT1 case.
PRINTING:
For best results, I recommend printing with 2 outer perimeters, 4 top/bottom layers, and 25% infill. Decent bridging performance is needed for the ~25mm bridges. PETG strongly recommended for outdoor/in-vehicle temperature stability.
Hardware needed (Amazon affiliate links):
10x2mm magnets: https://amzn.to/4eaHLRV
10mm Rubber Pads: https://amzn.to/3z4CSeq
The attached gcode is set up for two color changes and a pause for magnet insertion. These occur about 45 minutes in and occur on consecutive layers.
Layer 15: Color change
Layer 16: Pause to insert magnets
Layer 17: Color change
Enjoy!