Voron Trident Skirt Inserts (Most pieces also fit 2.4)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Complete set of skirt inserts to spice up your Trident without reprinting the skirts.
- Ocena
- 5 / 5
- Polubienia
- 86
- Pobrania
- 279
- Wydruki
- 6
- Wyświetlenia
- 1426
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a complete set of decorative skirt inserts for a Voron Trident, based on the great work of mrhartnett and Grafton1046.
The inserts have a tolerance of 0.1mm and are meant to be press fit. If a few may end up just a touch loose you can add some CA glue to keep them in place.
All files contain the number of copies you need to print for a full set. Only the amount for 2 main pieces changes between printer sizes, all other parts remain the same.
The bottom inserts for the fan skirts contain a tiny piece of inbuilt support that must be removed before trying to insert them into the skirt. The fan skirt pieces are also thinner then the rest and have less contact, so I strongly recommend glueing them in if you can.
If you use a flipped around fan mount you can just use the regular pieces, but you have to figure out the needed amount yourself.
These can also work for a Voron 2.4 if combined with the 2.4 specific parts from Grafton1046, the same goes about figuring out the needed amount of pieces