Cute Scared Pumpkin - LED Tea Light

Multi color print done with AMS - but you can add a pause and just change the filament for the top half of the print.

LED Tea Light used is ~37mm wide/tall, but the hole is pretty big so you could probably use other ones as well!  Just make sure its LED.

I recommend using Variable Layer Height for the bottom and top parts of the pumpkin to better smooth it out.  My original print did not use this and I wish I did.

If my model editing was better, I would make the hole concave on the inside more so that its closer to the walls to allow more light to pass through - but honestly I am still a beginner in regards to this so maybe in the future I will re-visit this.

Recommended Print Settings:

.2 Layer height (Variable Layer Height recommended for bottom and top)

Wall Loops - 4-6 (I did 6, but you could probably bump that down a little, the smaller wall the more likely light will pass through easier, but also more likely of a failed print)

Infill - LIGHTNING (very important so you dont see infill that much)

Infill Density - 15-25% (I did 25%, but again you could probably bump that down)

Supports - Not needed (inside does do a bridge, so you could support it if you want)

I also have this model available on my MakerWorld profile that includes the 3mf file with all the settings ready to go!

Happy Printing!