Cute Scared Pumpkin - LED Tea Light
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Remix that has a cutout for an LED Tea Light
- Rating
- 0 / 5
- Likes
- 11
- Downloads
- 38
- Makes
- 0
- Views
- 229
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Autumn & Halloween
- License
- Creative Commons — Attribution
Multi color print done with AMS - but you can add a pause and just change the filament for the top half of the print.
LED Tea Light used is ~37mm wide/tall, but the hole is pretty big so you could probably use other ones as well! Just make sure its LED.
I recommend using Variable Layer Height for the bottom and top parts of the pumpkin to better smooth it out. My original print did not use this and I wish I did.
If my model editing was better, I would make the hole concave on the inside more so that its closer to the walls to allow more light to pass through - but honestly I am still a beginner in regards to this so maybe in the future I will re-visit this.
Recommended Print Settings:
.2 Layer height (Variable Layer Height recommended for bottom and top)
Wall Loops - 4-6 (I did 6, but you could probably bump that down a little, the smaller wall the more likely light will pass through easier, but also more likely of a failed print)
Infill - LIGHTNING (very important so you dont see infill that much)
Infill Density - 15-25% (I did 25%, but again you could probably bump that down)
Supports - Not needed (inside does do a bridge, so you could support it if you want)
I also have this model available on my MakerWorld profile that includes the 3mf file with all the settings ready to go!
Happy Printing!