Magnetic USB+Powerswitch LCD case for Original Prusa MINI(+)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This LCD case attaches magnetically to the Prusa MINI. Remix of Levendigs' USB+Powerswitch mod for the Prusa MINI.
- Ocena
- 4 / 5
- Polubienia
- 7
- Pobrania
- 27
- Wydruki
- 1
- Wyświetlenia
- 195
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I remixed the Levendigs Prusa Mini USB+Powerswitch case to attach to the MINI magnetically. There are two parts, each housing a square magnet. One part (the “puck”) is fixed to the original LCD mounting location. The other part (the remixed LCD cover) is now magnetically attachable/detachable from the rest of the printer. The back cover plate (also by Levendigs) is available on their page.
Benefits: you can detach the case and operate the control knob at different angles with one hand! Also, magnets are cool.
Drawbacks: you have to support the case from the back when pressing the control knob.
Instructions:
On the LCD cover,
- Thread the screw holes using the existing hex socket head screws
- Fasten the LCD to the case
- Press the square magnet into the cutout on the inside, using a bit of glue or tape if the magnet is loose
- Follow the Levendigs installation guide
On the mounting puck:
- Fasten the puck to the MINI LCD mount using an M3x12 hex socket head screw
- Press a 1/2 in width x 1/8 in thickness (12.7 x 3.2 mm) square magnet into the slot.
Printing suggestions:
I printed the front of the LCD case in Prusament PC Blend Carbon Fiber (for aesthetic purposes) and the mounting puck and back cover plate (also by Levendigs) in Prusament PETG Prusa Orange. No supports were needed for any of these parts, but make sure to orient the flat face of the mounting puck and front face of the LCD case on the print bed.