Snapmaker Double Part Cooling Fan
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Part cooling fan holder for 2x 40mm fans. Connect with 2x M3x16mm screws to https://www.thingiverse.com/thing:2931459…
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 26
- Wydruki
- 0
- Wyświetlenia
- 898
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
Note: This Print is for the Snapmaker 1.0 which I don't have anymore.
Part cooling fan holder for 2x 40mm fans. Connect with 2x M3x16mm screws to
https://www.prusaprinters.org/prints/99879-snapmaker-accessory-mount-goes-nuts
or
https://www.thingiverse.com/thing:2816454
then it will cool your printed part.
Print Settings
Printer:
Snapmaker
Rafts:
No
Supports:
Yes
Resolution:
.2 layer height
Infill:
15%
Notes:
Print it flat on the mounting plate part. You would only need two small support towers for making the screw hole nicer, but you can even print it without support if you don't care about that.
Walls optimized for .4 nozzle.
Category: 3D Printer Accessories