Mulitple Cat Squeeze Tube Treat Feeder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Needed a solution to feed squeeze treats to four cats at once.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 29
- Wydruki
- 0
- Wyświetlenia
- 531
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Creative Commons — Attribution — Noncommercial
Yes you did read the title correctly…😉
The design gave me the idea on how to feed the squeeze treats to multiple cats. Usually the missus and I take two cats each and feed by hand but that is still difficult (with eager cats).
With this one person can give treats to up to four cats at the same time. Plus it dispenses the treats uniformly to each.
Printer notes:
- 0.15 mm layer height.
- PETG.
- On the MK3S, you have to lay the center stem diagonally on the bed. Just make sure the internal slot is vertical.
- Print the shell vertically.
- Make sure the ratchet knob is oriented with the internal concave pointing up.
- You should not need any supports or brim.
I provided the step file and hopefully it might make it easier to tweak it if needed.
One thing I did notice is that I had to trim back the underside of the locking lip on the stem as it was a little too short. You might want to try pulling it up 0.5 mm or so but I found that shorter is better as it can be finished to at tight snap.