1 / 3
Mulitple Cat Squeeze Tube Treat Feeder — image 1
1 / 3

Mulitple Cat Squeeze Tube Treat Feeder

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Needed a solution to feed squeeze treats to four cats at once.

Rating
0 / 5
Likes
10
Downloads
29
Makes
0
Views
532
Reviews
0

Updated at source:

Model information

Category
Pets
License
Creative Commons — Attribution — Noncommercial

Yes you did read the title correctly…😉

The design gave me the idea on how to feed the squeeze treats to multiple cats. Usually the missus and I take two cats each and feed by hand but that is still difficult (with eager cats).

With this one person can give treats to up to four cats at the same time. Plus it dispenses the treats uniformly to each.

Printer notes:

  1. 0.15 mm layer height.
  2. PETG.
  3. On the MK3S, you have to lay the center stem diagonally on the bed. Just make sure the internal slot is vertical.
  4. Print the shell vertically.
  5. Make sure the ratchet knob is oriented with the internal concave pointing up.
  6. You should not need any supports or brim.

I provided the step file and hopefully it might make it easier to tweak it if needed.

One thing I did notice is that I had to trim back the underside of the locking lip on the stem as it was a little too short. You might want to try pulling it up 0.5 mm or so but I found that shorter is better as it can be finished to at tight snap.

Tags