Liczymy pasujące modele…
After printing a couple other models that didn't seal properly, I decided to pick a well-designed model and make a few changes to seal it as much as possible. There are thee versions of the tray: The first version is meant to be printed…
Printed top-side down, without supports, and a brim to assist adhesion. See also Funnel for Spool Desiccant Carrier .
A revised version of a simple remix of a the Desiccant Spool Carrier for Bambu Lab's spools. It can be kept in the spool while printing and in storage. The initial remix replaced the holes in the lid with a cut-out for a hygrometer,…
Rilakkuma relaxing on a cushion. This was just a quick remix to eliminate the need for supports, using https://www.tinkercad.com/things/aNY30yChtgT and https://www.tinkercad.com/things/g8JyAXm5GEP for the mattress and pillow. Related…
I created this side-brace because I was unable to cut or order a length of 2020 extrusion to fit properly between the two side legs. It may be unnecessary, but I also added horizontal aluminum braces to the front and back.
There have been at least 6 versions of the AMS Bottom Cover Unit , each with variations on the number and size of vertical wall cavities. Because of this, it's been difficult for both modelers and makers to get the right fit. I've tried…
A remix of a remix of Bambu Lab X1 Gridfinity Base with a twist.
A spacer to increase the shelf height of Vesken Selves and Trolleys
It's a snug fit, but not too snug. It can be printed with or without supports but the bridging will make the fit a little bit tighter. The cutout at the bottom is just to get a better grip, but you'll probably need to tap it a few times…
A light diffuser to dim the status light at the top of the Linksys Velop Mesh WiFi router. It reduces the light but still allows you to see the status when printed with white fillament. The model is 2 x 12 mm, so when printed at 0.2 layer…
To wszystkie aktualnie dostępne wyniki.
