Liczymy pasujące modele…
Easy to print fully working YoYo. Print in PETG for the best results. PETG is easy to sand in a smooth surface. Print with a little paint on support as shown in de picture. Use a m4 20mm bold and nut, to fit the two parts together. Print…
Printed in PLA no supports 0.2 mm 100%.
Easy to print no supports bitholder with magnets
Print with PLA no supports needed at 0.2 layer height. Arduino code: //DIJKX #include <Servo.h> // servo library Servo s1; void setup() { s1.attach(0); // servo attach D3 pin of arduino } void loop() { s1.write(77); // 90 stops servo…
Print at 0.2 mm, 15% infill no supports. Print the top at 100% infill. Connect all buttons at one side to ground, otherside to a GPIO pin (see provided code) on the ESP32. Connect one pin of the LED to ground and the other to a GPIO pin.…
If you want to use them as coasters, print in PETG, PLA might melt. Print at 0.2mm layerhight or less, in PLA or PETG. Examples below printed on the Prusa Mini + at 0.2 mm in PETG and PLA. Add a color change in Prusa slicer at 3.2 mm. You…
This mount is designed for the 14mm rally bar on the 2026 Kawasaki 500 because the original Accooi mount is far too big. The design leaves enough clearance for protective tape around the bar to prevent damage. Print this model without…
To wszystkie aktualnie dostępne wyniki.
