Liczymy pasujące modele…
This is a patch cable holder that can be adjusted parametrically to your storage needs. Included here are 3x cables, 12x, and 16x STLs but you can have as many or few as you want - probably the main limitation is your print bed size.
A fully-enclosed housing for the Cytron CM4 Maker Board . This uses M3 heat-set nuts to attach the pieces together. Ingredients 8x M3x6 screws 8x M3 heat-set nuts This design is intended to be fully enclosed for dust ingress protection,…
Just print two of these and you can strap your Pocket Operators back-to-back for double the fun! Use with a short right-angle TRS ⅛" jack.
This tool lets you take bundles of 1mm fiber optics and light them up with addressable LED strips. This supports anywhere from 1-7 fiber strands per LED. To use you'll need two copies of the block holder (you can choose how many LEDs by…
This is a small bracket that takes a 23mm diameter addressable LED board and mounts it a good distance (12mm or so) from a 40mm diameter disc of black LED acrylic for a very nice glowing eye effect. It has holes around the edges so it can…
As an accessory to this AVR ISP Pogo Adapter , I created a little pogo pin protector to prevent the pins from becoming bent. The tolerances are pretty tight, so I had to ream the pin holes with a 1.5mm screwdriver tip so that everything…
An Openbeam rectangular plate generator. Portions Copyright: 2010 Marius Kintel 2-clause BSD License ( http://opensource.org/licenses/BSD-2-Clause )
This is a wearable orb holder aka a crystal ball pin. To make this, you'll want the following objects: 14mm diameter marble with a blue-ish iridescent sheen (you can adjust the diameter in the .scad if you need) small pinbacks sparkle…
To wszystkie aktualnie dostępne wyniki.
