Liczymy pasujące modele…
This is my self designed enclosure for a small portable node using RAK19003 . This version should take in all of the versions of RAK19003 but the LED locations are taken from version E (same as versions C and D). Following images…
Wall mount with two of 4mm and 3mm countersunk holes each. Four tension clips for easy attachment/removal of the SDR
Model was made because I didn't have the original desk stand, and the original desk stand would not fit on top of my existing radios. In theory the stand should fit CM360, 140 and 160 radios also. One leg is straight and other has a…
This mount introduces about 15cm of clearance (to the midpoint of the camera) from the mounted corner. I bet you can use any camera that has the mounting screw in use.
Sides and middle plates separately. Unfortunately I had some bad luck with tolerances in the slots where middle plates are pushed. Had to do some trimming with an exact-o-knife. Also I made a little measuring error so I had to print…
This was needed because I wanted to solve the housing problem for my MiniWhip antenna. It needed to be installed inside a PVC pipe and also having a possibility to replace the antenna if needed.
I observed that the probe was pretty slippery if you wanted to hold it by pinching while getting it level on a surface or near something on surface. Wanted to make some kind of extra handle to improve user experience and adding a…
I got this Suunto compass which has some radium paint in it and wanted to set it on display so a custom solution was needed. Just glued all the parts together with superglue
The model has four vent holes to protect the mica from breaking when you insert the cap
To wszystkie aktualnie dostępne wyniki.
