Liczymy pasujące modele…
How it works: Push skis in and up to allow for one handed operation (Strongest holding power at the thinnest point of the skis right where rocker starts) (Gif of older version, but use is the same) Changes: 12/29/23: Added new bolt…
Replaces original bolts to allow the Gravity Ski Holder to also hold poles. Print on the top face without supports.
Designed to be printed on a build plate 256mmx256mm or bigger (I print on a p1p). You need a set of pliers to pull the strap through the slot in the buckle THIS IS DIFFICULT BUT IT DOES FIT. Tight fit really locks the buckle in place. The…
Minimal Air pods Pro case that allows you to connect it with a keychain. Print on top face with no supports. Works with this charging doc: https://www.printables.com/model/603890-magsafe-airpods-garmin-charge-station
2020 extrusion used for main vertical beam. You can probably print your own extrusion because it doesn't need to be all that strong. Use phone to determine sharpening angle. Currently uses a cylindrical magnet to secure the knife to the…
Basic Steps: Scan foot in neutral position, I used EM3D which used the face ID camera on an iPhone to get a pretty high definition scan. Create many planes throughout the scan Create a sketch and spline following the curve of the foot on…
THIS DOES NOT FUNCTION THAT GREAT. PRINT ONLY IF YOU WANT TO SEE HOW IT WORKS. There is too much friction and needs a redesign with bearings or something similar. Printed in PLA with 6 walls and 35-50% gyroid infill. Ratchet allows 1…
Airpods doc is designed to be used with the “Minimal Airpods Pro Keychain Case”. Print with 40% infill to make the whole thing feel more premium. I screwed it directly into my nightstand, but you can either tape the whole thing down or…
Uses an old Leki speed lock and generic 5mm nut for hardware. Finished piece weighs ~30g including hardware. Pretty sure this is the speed lock version I used:…
Re-sized to have a strong hold when printing in TPU. TPU is ideal because it is without a doubt the most durable filament and highest layer adhesion of any filament I've used. I tried some in PLA and they were destroyed quickly. 2/6/23:…
Replace end of Zipfit liner laces with this hook to keep them more organized when booting up. Print so that the entire thing is made of walls I epoxied them on so that you can pull on the hooks to tighten your liners. No Support
The North Face Tadpole SL 2 uses Velcro ties to secure the archway pole. These clips use the velcro that is already there to improve how the archway pole attaches. I used 16mm m3 bolts and m3 heat inserts. When doing the heat inserts make…
To wszystkie aktualnie dostępne wyniki.
