Liczymy pasujące modele…
Print without supports, whatever type of filament you like. Unscrew the end of the SV08, slide Part A on, put the end back on, add filament, screw on cap. The cones should clamp on to the filament. There is a slot on Part A for a zip tie,…
Enclosure with wooden edges and thin plastic panels with a black iron pipe base. It's around $50 for the panels, another $100 for the wood, and $150 for the pipe. In Canadian dollars. I used 8 1.5" x 3/4" x 8' boards glued together to…
We had a member of our pool league join our team and he is in a wheelchair but because of the height of the chair he was unable to reach very far with his cue. We all brainstormed ideas to make a bridge for him that could be lifted up…
Use transparent filament and print as is, no supports, clean up the slot with a razor, but does print amazingly well for such a large thin pair of plates, or did for me. I can't get fully transparent, but semi is not bad.
One of the first things I 3D printed, it is somewhere to rest your cue on while playing a match. I made several variations over the years, this one uses a lead ingot, one piece of "pure" lead (rather than many fishing lures in a hole with…
This is an attachment for the Genmitsu Cubiko laser module to hold a hose in place for air assist. I have a 6mm hose, if you want another diameter let me know, I used 20% infill and grid supports, went full speed. You will need 2 3mm…
I did up a i2c acceleromter clip for input smoothing, attaches to the bed for Y and to the adapter for X.
Pretty self explanatory, it's a roller. You will need a 8mm allen wrench to loosen the print, or a screwdriver probably and I found jiffy lube helps a lot as well, you can inject the lube into the seam using that little straw thing. Crazy…
When making a diy circuit board, you may venture into applying solder masks so when you go to put everything together you don't accidently short things out. One approach is to cure the mask first, then use a laser or milling operation at…
It's a 2 foot wide circle with a 1 foot-ish wide hole in the middle of it that rotates with low friction. My idea was to have a 3d scanner mounted on the edge and go around the object rather than the object rotating. Also to be able to be…
This is a guide I did up for my pool cue lathe, so rather specific project, center is 110mm from the base, which is an aluminum extrusion. I am using 110mm tapered M5 bolts and extrusion track nuts , the FreeCAD file is included if you…
To wszystkie aktualnie dostępne wyniki.
