Liczymy pasujące modele…
This is a remix of a spool holder I found in January 2020, but I can no longer find the Thing. There are 5 parts: 2 Trusses 2 Knobs 1 Spool This spool holder requires 2 608 bearings. The parts are designed so that the bearings are a very…
I needed a solution to the wands for my pressure washer, so I designed them. The clips contain a countersunk hole for a screw, so a hole needs to be drilled into the pressure washer handle for each part. I used spare automotive interior…
I revised the cord wrap design to be smaller so the brackets would mount to a piece of 2×4 lumber. The holes are designed for #6×1.5-inch wood screws. Print Settings Printer Brand: Prusa Printer: I3 MK3S Rafts: No Supports: No Resolution:…
1. Introduction: After modifying the original design and creating V1, I discovered the base was bending and twisting in my vise when a blade was attached. Also, the pivot shaft was bending with a heavy blade attached. With these…
A common complaint about treadmills is that the feet wear holes in mats and carpeting. The cause is the small diameter of the foot, putting a large load per area onto the mat. This adapter fits over the original foot and spreads the load…
I like the basic design of this blade balancer. On my Prusa Mk3S, I chose to print the parts with PLA using 40% infill and at a 0.10 mm layer height for accuracy in the screw threads as well as for strength and appearance. No supports are…
This is my design for a single-point bench grinder diamond dresser. Additionally, I have included an adapter so the dresser can be used on an Oregon blade sharpener. The user must supply the diamond shaft and cut ½"-13 threads on the…
I designed this knob to fit the stone height adjuster on an Oregon Blade Grinder. Without the knob, a wrench is required to adjust the stone height. It is more convenient to adjust with a knob. The fit is designed to be very snug so it…
To wszystkie aktualnie dostępne wyniki.
