Liczymy pasujące modele…
See blur_457's original notes here and installation instructions here. The difference is that you don't need to use the metal dovetail block from the original cap, since the dovetail can be printed. I printed it out of PETG, but any…
Everyone who has flown one of these models long enough has experienced a cracked cowling. This is a printable replacement part for Guillow's 504 Supermarine Spitfire balsa model airplane. A tiny bit of infill with single walls compares…
Replacement wheels for Greenbrier-branded Pencil Holders shaped like garbage cans, recycling bins, etc. These may be sold under other brand names as well and may also be sold as “Barbie” sized curbside trash bins. I printed it as…
Kohler suggests using a wrench, but as this person experienced, the aerator still wouldn't budge. I made this tool to fit, and it successfully opened my faucet. I printed it with four perimeters, 50% infill, a modifier box for 100% infill…
A set of height spacers, designed to be compatible with GraviTrax marble runs / kugelbahn toys. No supports required - just print them upside down. They may be slightly snug right off the printer, but after the PLA cools down fully, the…
A holder to keep Speed Stick brand deodorant from tipping over. Default print settings work fine! Cut in half and use connectors for printing without supports.
This part provides a way to tap 12v from Rheem/Ruud Hybrid (Heat Pump) water heaters to power an ESP32+RS485 adapter for ESPHome-Econet without modifying the water heater. Models that lack WiFi provide 12V power over the RJ12 port, but…
These can be used to replace the plastic end caps on cellular shades (specifically, top-down bottom-up) from SelectBlinds / selectblinds.com. I am not affiliated with them but designed this since they don’t appear to provide replacement…
See LoboCNC's original for full details ! The only difference is that this is used with two-piece band and lid covers for mason jars. It's a significant reduction in print time for each ramp+trap set you make - over 45 minutes on my…
A small needle minder for holding sewing needles, using 5x1mm or 3x1mm magnets. Designed for layer-swap color changes (no MMU/AMS). The subtle white lines are created using an 0.08mm layer, which makes them translucent so the blue below…
A liner for IKEA’s 3.5” Glaciarbjorn planters. Supports not required if your printer handles bridges well. I use the default version, but provided a thinner single-wall variant.
A small version of Mjolnir, Thor's Hammer, which prints in two parts and holds two 5x2mm magnets. The FreeCAD source is provided so it can easily be modified. Great party favors (for children old enough not to swallow small objects)! I…
To wszystkie aktualnie dostępne wyniki.
