Liczymy pasujące modele…
While optimizing the placement of instruments on the pegboard, the original clips broke frequently. I created a version with enhanced spring strength and was pleased with their survivability. The original model can be found here…
Simple but beautiful stand for the original Rotating Rings Toy
Snapmaker 2.0 touchpad holder T-rail mount for original enclosure (A150/A250/A350) Allows you to place the control touchpad on the enclosure and move as needed. You will need: Original magnetic touchpad mount (remains unused after…
Sufficiently sized convenient and practical cable organizer of different thicknesses for Elfa a pegboard. One pair of clips is required for mount to a pegboard
10cm small tool cup for Elfa pegboard. You need (!) to print one pair of Elfa module clips
Dual Tape Holder for ELFA pegboard. Required one pair of module clips https://www.prusaprinters.org/prints/60471
60mm Fan guard for EIBOS 3D Filament Dryer CYCLOPES, but can be used for any other fan :) After the fan grill of my EIBOS Filament Dryer melted, I had to replace it. I liked the design of https://www.thingiverse.com/thing:1274150 and did…
Another caliper holder for Elfa pegboard. You need (!) to print one pair of Elfa module clips
Two version of sliding door handle for Snapmaker 2.0 A350 enclosure - version for two M3 screws (I used 2x M3x20 screws - sufficient strength for PLA) and version without screws (not to use PLA - very fragile. ASA/PETG/etc is better). The…
Easy 83mm small cup for Elfa pegboards. Required one pair of module clips https://www.prusaprinters.org/prints/60471 Based on remix of https://www.thingiverse.com/thing:2576053
Easy print EIBOS 3D Filament Vacuum Pump holder for Elfa pegboard. One pair of Elfa Module clips https://www.prusaprinters.org/prints/60471 is required to install on a pegboard.
To wszystkie aktualnie dostępne wyniki.
