Liczymy pasujące modele…
This is a 10mm spacer for the Eufy E340 doorbell that allows it to clear the trim around my door while using the 30-degree angled spacer. PETG works the best, but PLA would suffice in mild climates. 15% infill
This is a step-down converter to adapt the 200 CFM Ryobi One 18v leaf blower to fit in a Coleman air Mattress. I printed this out in TPU just to make sure the fit was good and the print didn't fly off, but it should also work in PLA. This…
Made this for hanging picture frames with built-in screw mounting holes, and based it on an existing model.
Print in ABS or PETG depending on application and environmental conditions.
Sized for 1 1/8" diameter fork and includes an extension incase your steer tube is longer than 5 ½". The total length is 11" when both parts are used. I recommend using PLA plus or Pro, do not use PETG it will fail. You should print with…
It was designed to be printed without supports and with the side that the pole enters on the bed. Depending on your environment I would recommend using a durable heat resistant filament such as PETG or ABS. Additional parts M4 x 16mm…
This end cap fits the larger gauge wire on the Closetmaid wire shelf, the internal diameter is 8mm so you can shrink it down to fit the smaller wire in your slicer if you know the diameter of that. Print in TPU and upside down for best…
This float valve is designed to block debris from entering your rain water catchment system from your first flush diverter. To use this print you'll place the ring between the Tee connector and 3" pvc pipe with the lip seated inside the…
I made these tall replacement feet to give more clearance under the pedal board so the switch on my power supply wouldn't be too close to the ground. These feet add about 30mm of clearance under the board. TPU is the best material to…
This is a replacement sliding lock for the Fiskars pruning scissor. Recommended Print Settings: .2 layer height PETG (but PLA will work too) Fuzzy skin on outward facing sides
These are spacers designed to create a uniform gap between your Gobi rack and the accessory you're mounting to the diamond mesh platform. I've included a 6mm and 12mm tall spacer as well as a 6mm and 12mm spacer without the diamond…
Simple adapter to connect a flexible downspout to a 3" schedule 40 PVC connector. I added holes to the side in case you want to use rivets to make a more solid connection but depending on your use it's not required. You can also add some…
This mount was remixed to fit in Vladimir Varzaru's 10 inch rack 1U 3xRPI mount using nano's RAK19007 WisBlock Base Board Mount to mount a WisBlock RAK19007 board in a 10 inch server rack.
This model was created with OpenTrailPaper in mind that uses the LILYGO T5-4.7-S3 E-Paper Pro as a bike computer. I've included models with buttons and without, as well as versions with a Quad Lock connector. You will need to print the…
To wszystkie aktualnie dostępne wyniki.
