Liczymy pasujące modele…
I don't like original MMU filament holders for a number of reasons: they can't be attached so they wonder around when placing filament; they have adjustable “rollers” which i absolutely HATE. I have different brands of filaments, and…
A box for DSO-TC3. I used original foam insert, I only added some to the top part, too (1cm thick to protect the top). I have cables stored separately, but i guess that you can squeeze test cables inside, if desired - just put them at the…
ESP32-4848S040 LVGL display wall mount dose. No holes, drill them where you need them after print. For two screws use heat inserts.
If your PTFE tube is too short you can extend it with this joiner. It uses same PTFE plastic coupling collets as MMU3 unit (like this one - EDIT: wrong, i just received them, those are too big! Use original ones from Prusa! ). If filament…
I didn't find any cutter who cuts filament in arrow shape, which is best if you have MMU3 unit. cutting with cutters is a pain… cutting wrong and filament will stuck when inserting. This remix cuts on both sides at 45 degrees, so end…
I have gewiss system switches in my garage and i needed blank cap for closing a gap. It's same as gw20056 model from gewiss. I printed it with PETG, 0.25mm step, but PLA should be also ok.
When you change the filament you want to put a new roll next to the printer while you wait for old one to be removed (and not the new one to be rolled off the table).
CR2032 batteries don't really "live well" in freezing conditions, so i converted one Xiaomi sensor to run on two AAA batteries. I added a battery holder on the stevenson screen from "Mepea". I uploaded only center part with battery…
To wszystkie aktualnie dostępne wyniki.
