Liczymy pasujące modele…
Inserts for the Packout organizer designed for ½ in. Drive SAE and Metric Tekton deep impact sockets, size ranging from 8 - 38mm and 5/16 - 1-½ in. as well as the universal joint, 3 in. extension and 10 in. extension. These inserts were…
*Be sure not to push the filament end in too much, as the hole is tapered and it may become too tight for the AMS to pull it out, I have been pushing it in about halfway as pictured and it comes out easily* No more hook ends at the end of…
Model designed to clip over the door hinge to keep it open at 110 degree angle, this is especially helpful with spring loaded doors as they always want to stay shut. I use this when bringing large items in the house and for bringing…
This should be printed in ABS or ASA to prevent warping under higher chamber temperatures Also print this with the back side faced down for best strength with tree supports on auto. You can see my top layer lines to see the orientation I…
For a clean install, check out my other wire guide model to cleanly pass the wires/PTFE tubes from the AMS’s to the printer https://www.printables.com/model/824452-wiring-port **this design is specifically made for the 48" Harbor Freight…
A combination of mounting devices designed to fit the pegboard on the 48" Yukon Workbench, they are designed to bold from the backside into the holes in the rear of the prints. The step files are included if you want to remix then with…
This adapter is used to install a 25mm Weld On Fuel Cap on to the steam knob on the Turin Legato. Insert the chamfered end into the side with the threads on it and press it in until it is flush. This is the product I used on my machine,…
A simple curved guide for the exit PTFE tube on the back of the AMS. Printed in PETG, but any material should be fine, just slide the PTFE tube through and butt it against the exit of the AMS and you're done.
A pass through guide to hold 2 PTFE tubes and 1 6 pin BUS cable for Bambu AMS. I have the Harbor Freight 48” desk which is what this is designed for, but it will work for any surface with a similar thickness of .35” or 9mm or thinner. To…
To wszystkie aktualnie dostępne wyniki.
