Liczymy pasujące modele…
Be kind, this is my first big FreeCAD project 🤣 This is a reloadable film cartridge for the Mamiya 16 line of subminiature cameras. 16Sept: Currently undergoing testing for light seal and usability 27Sept: Changed the take-up spool to…
Print only the frame and hood with supports. The Magnet housing and side blinders should print without supports. Use standard 1.75mm filament as the hinges and melt the ends to seal them onto their respective parts. Uses two 9.5x1.5mm…
Simple winding tool to help make antenna coils that go into the frames here on Thingiverse Good for <= 2mm dia. wire (Should use solid copper for best performance!) This is a good write-up about these antennas, use right-hand coils for…
Adjust the FreeCAD project to match whatever lens you wish to mount
Use a standard LR44 battery to power a Canon Dial 35 (Version 1, as the 2nd version natively uses the LR44). This print uses some 18AWG wire that I sanded the enamel off of, although any wire that fits should work.
Best printed with <20% infill in the vertical orientation. Non Printed Parts: - 2x M3x20 screws - 2x Spade Connectors (I used 20AWG because I had them on-hand) - 2x M3 Washers - 2-Conductor wire See the attached photo for how it all goes…
This is a two-part print to put a 4x5 ground glass in a Polaroid MP-4 Copy Stand Camera . The Fresnel lens goes in front of the ground glass with the rough surface of the ground glass being sandwiched in between them. Due to how the…
To wszystkie aktualnie dostępne wyniki.
