Liczymy pasujące modele…
For a better printing, put the holes where the screws will go attached to the print bed, so that you have the most external part of the shelf at the top. ATTENTION I RECOMMEND USING THE SHAFT SUPPORTS TO MAKE CLEANING THE SUPPORTS EASIER.…
I searched for a long time for a way to attach the power supply of my G29 on which side under the desk I use, and since I couldn't find any, I did it, the measurements are right, I tested it for the G29, but I suppose it's also good for…
the support was made for the heatsink in question, mounted on a Tesla M40 nvidia, before with the 120mm fans it went to a maximum of 45/50 ° with this support for smaller fans, it went to 40/42 ° maximum, P.S. I used the noctua 92mm slim…
cable post for ANX truck gearbox but it can also go with any other way, I made 2 slots for 2 clamps with a width of 3.45/3.50mm printed with light weight media and if possible for easy printer cleaning without brim truck knob i used :…
i got tired of having only 2 front usb 3.0, so i redesigned the original front panel which only had 2 usb inputs, now i can put up to 6 usb 3.0 to connect everything here i need. I leave tinkecad link where I made the project:…
To wszystkie aktualnie dostępne wyniki.
