Liczymy pasujące modele…
Made some changes to allow for separate mounting of each antenna, also created one version for the high gain antenna (7108/7308 etc.) and the regular gain antenna. _________________ This part is simply to make it easy to set your…
Updated with an 85mm main cone diameter for smaller nosed models. Overall length remains the same. ______________________________ Updated the files - I increased the thickness of the cone so it will print with 2 walls to improve the…
Made some minor adjustments to the design - use V2 file to get the newest one. ___________________________ This is a control horn, 23mm high that is suitable for modern F3A competition models. It is designed to be used with bearing or…
Print with a high temperature and UV resistant material like ASA, ABS. Designed to be printed on its side, with no supports. Use a high amount of infill to provide strength to the base of the ball socket. Ball socket is 17mm in diameter…
This is a holder and mounting for the TM-18 module for the 32MZ. You will need 2mm or 2.5mm heat press inserts that go into the mount that is taped to the 3MZ. Double side tape both the TM-18 mount parts to the TX and to the TM-18 module.…
Tool you can use to install and remove the nuts for the props on the VLV Contra Drive. I use a 0.6mm nozzle with 0.3mm layer height. Any material should work well, but the stronger the better!
Parts to make a removable battery tray. I recommend printing with 0.6mm nozzle and 0.3mm layer height. You will need 4 of the tube holders and 2 of the tube locks. You install two of them horizontally and two vertically, so you can slid…
A simple mount to hold the VLV ESC - use some carbon rods across the fuse and glue in place. Some velcro or zip tie around the ESC.
Simple drill guide to help align the bit 90 deg to the work surface.
I found the wireless charging dock on newer Mastercraft boats to be too large for my iPhone 12 Pro, it would tip over or move to the side and the charging would stop. This spacer will better centre the phone over the charger and allow it…
Three parts are included in this upload. The wing adapters just glue straight into the opening that comes with the kit. You may need to slightly open it up as the fit is very tight. Just glue them down with epoxy to the existing frame,…
I made these to use instead of doubling, tripling etc. up on the single washers that come with the drive. So if you need 4 washers, just print the x4 spacer and you only have 1 part to deal with. Or easily replace lost washers, or keep…
To wszystkie aktualnie dostępne wyniki.
