Liczymy pasujące modele…
Update: I forgot that the Ender 3 KE has a different spool stand, with an additional part that makes it incompatible with my model. As such, I've updated my model to support the KE stand. Please let me know if it's still incompatible, in…
Note: Use the V2 printer clip. I realized that the filament sensor going down was limiting the printer's ability to print above Z200, as such I've essentially flipped the mount so now the sensor sits above the gantry cap. I forgot print…
These are designed to allow for simple cable management within the beam running across the desk. The pocketing grants less material usage, ability to pull cables through as well as squeezing thin plugs through. Two of these have the…
Due to the short cables of the BMS cables, it had to hang from the battery terminal. I didn't like that so I made this. Given the screw holes on the back, it made sense to use them. Installation is simple. 4 countersunk M3 screws in each…
A square of mounting tape on the flat side is more than enough to hold it.
This is certainly not perfect as I was skeptical about the flexibility of the PLA I was using, so the notches which snap into the display's bizarre mounting holes are rather short, but from my testing they're enough for holding the…
This is designed to be taped underneath the desk with mounting tape. Due to the position of the USB-C port, the angle at which this can be placed is very limited and this is the lowest I could get it. The macropad should just friction fit…
Please excuse the bad saturation in the color layers in the example picture, I don't have orange filament :(
To mount this, you'll need M4 threaded inserts pressed into the 2 holes which hold the datalogger into place. The hole diameter for the wall mount screws is ∅6mm.
No idea how you're supposed to lose it, but in case you did, here you go. Ideally you'd use a resin printer, but if you have a well calibrated printer you can print this with FDM. Some fine stringing may be present, but that can be melted…
A simple yet effective water-resistant holder for a 10W cob LED light which can be mounted with M3 screws to a lid or something. I created this for my aquarium since the original light broke and other lights I tried didn't resist to…
CPL filters available to buy for this dashcam are insanely overpriced and pretty flimsy looking. A generic 37mm filter is way cheaper and, with this adapter, you can put other filters too. 37mm happens to be a perfect filter size as it…
If you want the tool holder to be on the right side of the keyboard instead of the left, you can mirror the model along the X or Y axis in the slicer to get that effect. The other foot can be placed on either side so it doesn't matter…
This holder was modeled after the Faber-Castell S markers, although the other tip sized markers should fit too, as well as any marker that's less than 12 mm in diameter, these are just the only ones I had on hand. It can be mounted…
This tray was always quite awkward. Everything slid around in there, not really knowing its place. Since I don't like wasting things, this is not a replacement to the included tray, instead it docks inside and snugly snaps in with little…
For mounting you're going to need 3 self tapping screws, after which you can slide it down onto the pegboard. Vertical mounting is also possible. Tolerances for these panels differ from batch to batch, some panels are thicker, some are…
To wszystkie aktualnie dostępne wyniki.
