Liczymy pasujące modele…
no Support, print horizontal, 10% infill, in bright colors, PETG white worked perfekt for me, my green laser shines right through so i could see the position from the back also
Cross Line Laser Mount for Telescopic Ceiling Support Clamping range: approx. 32 to 40 mm Hardware: M12 Nut and Bold and…
No Support, 10% Infill, Print vertikal Fits Perfekt w/o transparent Sleeve. 101% Should to the Trick if Sleve is on Maybe old Version of Remote see Pictures! Example…
This attachemend could used via IoBroker, A-Echo, zigbee Hub.. see Amazon Open and Close Position are tracked because the magnet travels on the sled! Nice to switch Zigbee LED Stribes when Door is open/close/drives. Send Messages,…
Cap can be printed in Vase Mode. I removed the LED (Resistor) on the Neopixel Board (way to bright). The one on the ESP is aligned with one RGP LED Ring. So the Status (on/off) of the ESP can also (not as Bright) been seen in one Segment…
No Support, 50% Infill, no clue needed!
I build this Device so my daughter could send “cannot sleep” messages to our Phones. DC-DC Modul: https://shorturl.at/Lm2Zz Aliexpress The ESP is flashed with Tasmota: https://templates.blakadder.com/ESP-01S.html Integrated “Nightlight”…
The KeyKeep Door Knob Adapter is a practical 3D-printed solution designed to keep a door key permanently attached to German interior doors. It was developed and tested for Hörmann steel doors, but it can also be used with many other doors…
Function The holder attaches to any ferromagnetic surface — car roof, sheet steel, trailer, tool cabinet, etc. — via two embedded neodymium magnets (10x10x10 mm). The fishing rod is placed into the 20 mm opening secured with the rubber…
To wszystkie aktualnie dostępne wyniki.
