10 modeli
I made the walls thicker so it's sturdier and added a sliding lid. Lid has a tolerance of 0.08mm on each side. Printed on my SE and the lid slides perfectly. I recommend printing the box first and then just a section of the lid to make…
This is a CR Touch Spacer for the V3 KE/K1 Hotend installed in the V3 SE. I based this spacer in the Volcano bracket by T3KPrinter as I did'nt think printing the whole bracket was necessary. You will need two longer M3 screws as the…
WARNING Use flush cutters to cut out a piece of the “Cover” that presses against the SD Card. When modelling this i did not account for the SD Card protuding, so the cover will press against it and that can break the SD Card Slot.…
The Odrive Mini’s USB-C port points straight up from the PCB, making it easy to bend or break if bumped. This guard reinforces the connector and reduces stress on the solder joints. Just print it and install it in place of the original…
Inspired by the Polybar & Minibar Project by /u/roadsidebomb. I wanted a compact Clone Hero controller like the Minibar, but since I’m used to playing on a keyboard, I found the guitar-shaped buttons too far apart and less comfortable. To…
Designed for a hoverboard motor conversion using the FFbeast or OpenFFboard firmware with a MKS Odrive Mini controller. This is a compact, fully 3D printed enclosure that relies entirely on printed parts, standard bolts and nuts to hold…
Remade the model in a new style, brought it closer to the bed, made it fit my silicone brush better, modeled three different attachment options: Mid bed. Has an empty slot in the middle to allow it to clip to the middle of the bed frame.…
Kitchen towel hook that has a great grip on the towels. Won't let the towel slip away. I didn't like the looks of the original hook so I remodeled it while referencing its gap, as it has the best grip on the towels of all the similar…
A mount with the garmin connector for the Bafang DPC18 display Needs supports and I recommend printing with brim. Print it upright, like in the picture.
Remix of Electric longboard remote by DroidSector. Uses completely different hardware. Required Components 2× ESP32-C3 SuperMini microcontrollers (remote + receiver) 49E Hall effect sensor (throttle position sensing) 2× 5 mm neodymium…
To wszystkie aktualnie dostępne wyniki.
