Liczymy pasujące modele…
Modified the original by cutting the model and moving it so the mounting holes are at 100x100mm spacing. Then extruded the cut sections back so that the original mount still works the same as it used to.
A little jig to help with lining up and inserting magnets into the pockets at the bottom of the bins. There is a press fit magnet spot on the top (or bottom depending on your perspective) to hold a magnet so that you can keep your magnet…
All the cable clips I had downloaded were too small. I'm using some woven flexwrap around my cables, so they're a bit fat. This clips into the extrusion channel. Not super tight, but not loose either. 13mm inner diameter, 16mm outer…
Optimized the slide in magnet pockets for a better fit
Simple mounting arm to hold the Ender 3 Filament Holder Deluxe. Holds the center of the spool 100mm offset from the center of the 2020 extrusion. Mounts to the 2020 with M4 cap head bolts which countersink into the body of the arm.…
Mounting for a piece of 2020 extrusion to use as cable management. Mounts to the top of the effector for the AnyCubic Kossel. The mounting bolts will need to be swapped out for longer ones. Instructions originally use M3x8, will need…
Liked the concept of the adapter ( https://www.thingiverse.com/thing:3297987 ) and filament holder ( https://www.thingiverse.com/thing:3114139 ), but I found the fit of the base project to be a bit too loose for my liking. It still works…
To wszystkie aktualnie dostępne wyniki.
