Liczymy pasujące modele…
With this Air Guide for the Fractal North a 140m can be put in the lowest position an all the airflow is directed to the GPU Printed with front facing side down. I would recommend a brim or helper discs at the narrow parts.
Wanted a simple and space-saving holder for my Steelseries Headset. It mounts just to the front panel of a Fractal North PC case (not tested with XL) Printed in white PLA on the side with supports for the hook. Used 3 perimeters for…
Print in filament of your choice. I used PLA with 0.4 Nozzle an 0.2 layer height Set seam to “next” to get a nicer finish on the hexagons Use “octagram spiral” bottom fill pattern for best look
I wanted to start my NAS project with NAS ITX PC case by @haydnbao https://www.printables.com/de/model/590711-nas-itx-pc-case-with-stackable-expansions I just wanted to start with two hard drives and didn't want to print the whole lower…
My wife wanted to test my modeling skill, I needed a justification for the 3D Printer. The is now very happy :-) Printed it in PLA with 0.4 nozzle and 0.2mm layer height
Needed a simple hook to hold up my e-bike for changing wheels, brake pads and brake discs. It's easier and fast than to use my bike stand out of the basement Just use some rope to hang it from the ceiling and some velcro around the break…
As requested, I designed an X-Box controller holder for the front of the Fractal Design North case. Printed on the side in PLA with supports for the hook. I made two variants: one in the same width as the headset holder I designed and one…
My son wanted to make a “Hospital” birthday and wanted some fitting cookies. So I designed as syringe an and band aid. I also designed a syringe with scale, but didn't test it yet I printed it in PLA.
Printed with white PETG (for flexibility): Nozzle: 0.6 mm Layer height: 0.2mm Vase mode 6 bottom layers Since I use a LED lamp, I don't have any temperature problems
just added the hexgons from Multiboard
The original feet of our Bosch MMU4 machine were broken. The replacement would have cost 15€+ so I designed new ones Printed in “extrudr TPU flex medium” and I used the “FLEX” setting from prusa slicer with the following adjustments:…
I wanted to have a better viewing angle for the NOUS E6 Temperature Sensor and a black cover to match my desk setup. The sensor is also available at AliExpress as "GIRIER ZigBee 3.0 Smart Temperature Humidity Sensor". Printed in your…
I had enough of the salt and pepper crumbs on the table and designed a simple stand to collect them. The inner diameter is 63 mm Printed with wood fill filament
outer diameter: 53,5 mm inner diameter: 26 mm distance of side hole to top: 55 mm top diameter: 65 mm
The feet of my Weber Q2200 Stand got a bit rusty and made stains on the ground. So i Designed some feet for printing with TPU.
To wszystkie aktualnie dostępne wyniki.
