Liczymy pasujące modele…
Hello Guardians! This is a simple model that you can slice and print to make a hollow ghost shell. It is easy to multi-material paint - a sample 3mf is included below with four colours and the split plane already set up! The base model is…
Clutch discs have to be centered in the pressure plate when you mount up the clutchpack. This tool allows you to center your clutch disc easily by inserting it into the clutch disc, then inserting the tool nose into the flywheel bearing.…
The Bernina 1000-series machines have a small accessory box that attaches to the back of the freearm. This box has a small grey clip latch that can break, allowing the box to flip open and lose its contents. This clip is a direct…
A really simple base for a Sanwa-style joystick. Because making your own fightstick is way way cooler than just buying one! This joystick bas works for top mounting or base mounting. I have it base mounted on the fightstick shown. If you…
Back in 2024, Bungie ran a baking contest and this was my entry. It's a two-part mould you can use to make Destiny Ghost-shaped cake pops. Each pop requires two of the pieces this two-part mould makes. Surprise the Destiny players in your…
A really basic bit that will plug a hole in a cabinet door. I recommend printing with supports. These tuck in with a gentle press and can be removed by twisting out. It's not very special but it can make your day better.
This is the elusive lower iron support that holds the wiring harness for a Waring WMK300 waffler. It will work with all of the 300s as far as I know. Print it out of PETG minimum. Those suckers get hot. You may want to make a couple of…
Very basic bobbin tray for large Singer 211U bobbins. Keeps them from unspooling and from leaving the sewing table. Not really special, but nice to have.
Requires XL2T or XL5T or MMU! A 2-part model that should be printed with TPU for the nub and PETG for the visible part. You have to really push it in there, it is a tight fit so it won't fly off at speed. This end cap will replace the…
Little trays that your robotics students can use to sort their Nylock nuts that inevitably get confused in the hardware drawers. Just fill and shake back and forth and the ones that are too big will stay in the tray. Conversely, the ones…
A small but mighty bracket that will support your EGO 615 Leaf Cannon. Please screw it into a stud!
The video game Destiny 2 has an active modeling community. This is a model for the ghost shell Photovoltaic. It is multi-piece and requires gluing to complete. The model has features that will work well for multi-material printing. The…
This is a two-part model for the NLA bobbin winder traction wheel for Singer 211 machines. It may work for other machines also, but I only have a 211U. The larger part is a mould that is used to make a urethane casting (about 10ml of…
A small squaring tool for checking the studs that support the bell housing in a Toyobaru twin. Needed because I bought an engine and the studs arrived bent. This enabled me to put new studs in and check that the upper oil pan that the…
I made up the ESP32CAM from the Prusa Blog and decided I wanted my own box. It is a very slim model with a joint at the back. Ports for the power cable, an SD card, and both reset buttons are included in the model. Reset is marked with an…
To wszystkie aktualnie dostępne wyniki.
