Liczymy pasujące modele…
This Phase 10 box is a variant of the card box by Gino Goole which was a remix of the UNO Card Box by Markus_p . The .3mf file contains all parts needed - box bottom, box top, latches, card tray. I printed everything with 0.16mm layer…
This replaces the stock Traxxas Maxx (v2) battery latch system with a velcro strap system in order to use larger batteries. Just remove the two bolt on pieces and replace with these printed ones. Uses the stock screws for the front and…
The .3mf file has both the tray and six labels on two plates. I wrote on the labels with a Sharpie and designed them to be replaceable if you ended up with a different size battery that will still fit in the slots. It was designed in…
These spacers will clip onto the roller pins of a garage door to keep the door in a certain lateral position. These fit a roller that is 11mm in diameter. The spacers are 5mm wide. Printed with Bambu Lab PLA Basic, 0.2mm layer height, 5…
Risers for an ASUS PB287Q 28" monitor. Supported on the four corners and allows cables to go beneath monitor through a hole in the desk. The gaps around the monitor base are not symmetrical, so the risers are in pairs and will only fit in…
This battery tray attaches to the body of the Traxxas Maxx V2 and is designed to hold a Tattu 3S 1300mah battery for an auxiliary power supply for an FPV setup. It is designed to be used with a 16mm wide hold down strap. The strap hole…
To wszystkie aktualnie dostępne wyniki.
