Liczymy pasujące modele…
Add this as a negative volume on your PrusaSlicer and you'll be able to add hanging slots to any of your prints quick and easy! It works well for #6 screws. #8 screws are a very tight fit as-is, so just scale the model a bit larger and it…
Center skid plate for the Axial SCX10 RC crawler. This gives you a little more ground clearance to prevent getting hung up. This skid plate DOES affect link geometry slightly. There are 2 version, once for the stock links using Axial…
I like the original a lot, I just need to sand into a corner, so I added a wedge. A better person would have adjusted the whole model to make it so the same length sandpaper strip would work in both…I am not that person. Please go…
Whipped up some scale first aid kits for RC crawlers. Easy and fast to print. I suggest painting the cross red for maximum effect. For even more cool points change to a red filament when it starts to print the cross. There are 2 files,…
2021 Update: I don't recommend this design. Never got around to finishing it or making it work properly. Update 03/22/17: Updated to 3.10 version. Some tweaks to clearances around transmission. Update 03/16/17: Uploaded re-worked design.…
Designed this for a friend to adapt his monitors (Viewsonic vx3258-2kc-mhd) to a VESA mount, this is 100x100 spacing. I printed them out of carbon fiber polycarbonate. You'll need M4 screws (maybe about 20mm?) and 4 M4 lock nuts to attach…
Updates: Aug-10 2017: 2.0 update. Was not happy with uneven clamping. Increased clamping screws to 6, decrease mounting screws to 2. Tweaked front cap to maybe print better in ABS. Aug-9 2017: Added a notch to outside of rings and inside…
This is a simple fairlead for the Axial Wraith. Mainly applicable if using a servo winch setup. Designed around the stock servo on axle setup, I have not tested with a CMS setup, and I don't have any interest in putting CMS on my Wraith…
I created this simple foot for a 36x18x18 terrarium. Stays in place with a press fit. Simple and removable. Link to the terrarium: https://a.co/d/7faTcwD
Need to print 3 ribs, and minimum 2 spars (recommend 4 or 6). After you print the frame simply cover with plastic wrap, or any other clear plastic. You can add a few spars on top to hold the plastic on, or tape it on, or whatever you…
This allows me to use some random suction cups I had on hand to stick the wireless sensors to the inside of a reptile enclosure. I doubt this will be a direct fit for many suction cups due to the wide variation of suction cup ends, but…
To wszystkie aktualnie dostępne wyniki.
