Keyhole Slot for Wall Hanging
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Add this as a negative volume to anything to make it wall mountable.
- Ocena
- 5 / 5
- Polubienia
- 217
- Pobrania
- 3415
- Wydruki
- 4
- Wyświetlenia
- 9360
- Oceny
- 8
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Add this as a negative volume on your PrusaSlicer and you'll be able to add hanging slots to any of your prints quick and easy!
It works well for #6 screws. #8 screws are a very tight fit as-is, so just scale the model a bit larger and it will work for them as well.
For the metric world, here are the dimensions: The slot is 4mm wide. The hole has a diameter of 8mm. The slot is 8mm long. It will accommodate a head depth of about 3mm.
If you're resizing this to fit a different type of screw I'd recommend printing out a few test slugs to verify fitment. Each test slug should only take about 10 minutes to print.