Liczymy pasujące modele…
Introduction This project was originally made for a Sky Watcher 150 PDS, which have the flimsy secondary mirror holder we all came to love at some point. My goal was simply to make a sturdier replacement. But, CNC machining is expensive,…
I didn't like the holder for the Synscan that came with my EQM-35, so I designed my own by taking inspiration from the motor controller holder (that also came with the mount). It's made for Skywatcher's steel tripod that comes with EQM-35…
This model was used during software development when I wasn't sure the motor would suffice for my application. There are 2 kinds of markings on the ring : The smaller are spaced by 5 degrees The bigger are spaced by 30 degrees The rig was…
For modeling purposes. Don't use plastic to hold astronomic equipment.
Important : This model was only tested on the Wanhao duplicator I3 mini, it should work on any clone with the same fixation. Please, post a comment if it doesn't quite fit or if it needs a modification to work on your printer. Reasons :…
This holder clamps on Skywatcher's steel tripod legs and offers a place to store the battery during use. It's made for Skywatcher's steel tripod that comes with EQM-35 mounts and above. Those USB-C PD power tanks can provide up to 12V at…
Astroguider : C-Mount to Pentax-K Scope : This is a glorified adaptor for C-Mount astronomy cameras, it mounts on a Sky Watcher dovetail with two Kodak-thread holes separated by 3 cm. It is configured for SV Bony SV305 camera which have a…
Made this model after trying KB9RLW's since his version doesn't fit newer Tecsun PL330 models. In case your printer is calibrated to print slightly larger (like mine), I also provide a tight version.
I needed a case for the Olimex Gatemate FPGA dev board that protected the connectors while still allowing for wires to be plugged-in. There are no holes to access any selector or jumper since I never change them, but buttons are still…
To wszystkie aktualnie dostępne wyniki.
