P
Printablesgam3fr33k
Tragedy and Comedy Theater Masks
Remixed model to lay flat for wall mounting.
- Pobrania
- 392
- Polubienia
- 24
- Ocena
- 0
Wszystkie modele
Liczymy pasujące modele…
P
Printablesgam3fr33k
Ford Focus 2000 - 2011 Hood Prop Rod Grommet
Needed a replacement grommet for my 2005 Ford Focus. This one was almost exact, so with some minor changes this fit perfectly. You may need to file the nodule off the prop rod to make it fit, or file the grommet slightly so it can slide…
- Pobrania
- 179
- Polubienia
- 17
- Ocena
- 5
P
Printablesgam3fr33k
65 Mustang Falcon Galaxie Fresh Air Vent Baffle Diffuser
This is a reproduction designed from scratch using dimensions from a Ford original floor fresh air vent baffle, specifically for a 1965 Ford Mustang. The part number is C4AB6201820A. I have never found any reproduction for this part, and…
- Pobrania
- 59
- Polubienia
- 9
- Ocena
- 0
P
Printablesgam3fr33k
CBR250R CBR300R CB300f Rebel 300 Fork Guards
Fork guards specifically for the CBR250r, which are 37mm forks. These are found on many other smaller retro and older Honda models. This should fit any with the standard 37mm forks, but the bulge diameter at the top may vary, and I am…
- Pobrania
- 56
- Polubienia
- 11
- Ocena
- 0
P
Printablesgam3fr33k
Atlas Craftsman 10f TH36 TH42 TH46 TH52 lathe Crossfeed gear
My crossfeed gear key had been sheared off by the previous owner, and since everything is made of Zamak, there was no way to really repair it without silver brazing as solder would not stick and the original material melts at a very low…
- Pobrania
- 40
- Polubienia
- 1
- Ocena
- 0
P
Printablesgam3fr33k
Ford 8 inch rear differential gasket
This gasket fits 8" Ford rear differential carriers from the 50's and up. Not sure of exact years when they stopped this design, but this was made specifically for a 1965 Mustang with an 8" factory rear differential. The holes line up…
- Pobrania
- 26
- Polubienia
- 4
- Ocena
- 0
P
Printablesgam3fr33k
Neway valve seat cutter bushing - 6mm stem
Working on an old ATV that needed a valve seat regrinding, I purchased a vintage Neway 102W small engine valve seat cutter tool. All of the valve guide pilots were either too small or too large for the 6mm valve stem, so I made a…
- Pobrania
- 3
- Polubienia
- 0
- Ocena
- 0
To wszystkie aktualnie dostępne wyniki.