Liczymy pasujące modele…
I made this version of the arm pads for TBS Source one V5 to keep off the ground on hard surfaces. It fits all arms, but the model isn't 100% symmetrical, so there's a mirrored version to line up perfectly Filament used: TPU Print…
This jig can be used to sharpening any chisels or handplane blades on a whetstone. Needed: M8 bolt M8 nut 2x 8mm rods Ball bearing with 8mm inner diameter You can make this jig as big as you like with different rod/ bolt lengths…
This roller arm is for the filament to smoothly slide out of the dryer at a 90 degree angle to the printer without excess rubbing on the PTFE tubing, which without the roller found created a lot of friction and caused problems during…
I created this headphone holder with the zombie bust (created by Scott Mcdonald) Needed: 4x 8mm neodymium magnets These magnets are glued in place with epoxy.
To wszystkie aktualnie dostępne wyniki.
