Liczymy pasujące modele…
This is a remix to make a giant ball bearing, 200mm in diameter! It does need supports under each ball, but I found the tree type supports to break off cleanly and easily. The bearing runs well as printed but smooths out as you run it…
This is a remix of a remix to make a smaller print in place ball bearing with a 100mm diameter. It does need supports under each ball, but I found the tree type supports to break off cleanly and easily. The bearing runs well as printed…
I loved the original design but remixed it to change the alignment posts into holes sized for M3 screws. For the full model, you'll need to print two of the side plates. I printed the original model out PETG and glued it with CA glue.…
This is a remix to make the largest print in place ball bearing I can fit on my print bed, 250mm in diameter! This is not a simple scale up that would have thrown off the tolerances and created excessive play in the bearing. I've scaled…
I’ve always enjoyed the statue ‘The Thinker’, and when I heard about the Scan the World project that has posted 3D printable models of thousands of famous artifacts, I went looking. If you have not seen this site, it’s worth checking out…
To wszystkie aktualnie dostępne wyniki.
