Liczymy pasujące modele…
I love the 5015 fan duct from @ScatteredCollectable . I also love the Sovol SV06 Heat Bed Cable Support from @bulbasaur0 because (unless I'm missing something) it installs hella easier using zip ties instead of bolting to the heat bed…
I honestly don't know where else I would end up using any 10x15x4mm ball bearings that the original heat set press model calls for, so I snagged one of the two bearings from these rollers that I had ordered for the project (easily popped…
I love Grant's socket holders, but I tend to print a ton of my stuff in PLA+ (eSun High-Speed PLA+, to be exact). In order to guard against sagging and how I can sometimes be less-than-gentle when replacing my tools in their homes, I've…
I've always liked the flexibility of @Sneaks' Articulating Camera Mount system that I was running on my SV06 previously . I wanted to just transfer my Microsoft Lifecam over to my new AD5M... and so here we are. NOTE : this is only to…
Designed to be used with LM2596 LM2596S DC-DC Step Down Variable Volt Regulator Input 3.0-40V Output 1.5-35V Adjustable Buck Converter Printed low-quality 0.28mm Duramic 3D PLA+
I found UltraDave9000's remix the perfect general holder for most everything Ryobi that I have. However, my model P238 One+ Brushless driver has larger belt-clip mounting bumps on the base, proving to be too wide for either…
I needed something between the "wider" and "big" sizes that would hold three wrenches / spanners. I found that the “big” holders from @EthanMackenzi_326499 's design would just allow my wrenches to fall over. Making these go three-wide…
The Tapo C100 board cover needed some tweaks to fit better. The included PCB mounts also needed to be tweaked a little to work around the plugs on the board. I also found the side mount was too short (see photo) to line up with the…
To wszystkie aktualnie dostępne wyniki.
