Liczymy pasujące modele…
The frame would be printed as shown in attached picture. I used 6 perimeters, 50% gyroid infill. Printed in PLA. Thread has a clearance, printed on my mk3s+ and I didn't have any problems to install the screw. The frame is capable of…
New spring stop for shock absorber for 1:16 RC buggy from XINLEHONG. The original one was lost. Parameters of the shock absorber: length: 77mm, width: 14mm, hole: 45mm. Using various colors can result in attractive modifications.
This is my version of the holder for QuicRun 16BL30 ESC switch. The 0 and 1 indicators are printed in white. Two 2x14 screws are required, installation is a bit tricky, because the screws holds the whole thing together.
This is a holder for Odroid 2N with a large heatsink that can be mounted on the bottom of the top of the case (or on the wall). It consists of two rails and one base. A hole on the side allows you to secure both parts against spontaneous…
Wall mount holder for remote controler. Fixing via double side tape or two screws. PLA/PETG.
I wanted to safely stretch wires from tail LED light to receiver/lights unit. This conduit is placed at the bottom side of the wheel house and connects the side where tail light is installed with interior of the car. The only tricky part…
To wszystkie aktualnie dostępne wyniki.
