Liczymy pasujące modele…
I don't know about you, but I seem always to be acquiring tins like these so I thought time to put them to good use. After printing out a number of trays to hold things like lock pins, springs and other gubbins I thought it may be useful…
This is a remix of Jeremy702's great non-low profile case. The main changes are to move the Micro SD-Card slot from one end to the other and to add an opening so you can access the ON/OFF switch on the PiSugar2 power board. Print Settings…
This is a simpler version of a holder which enables lockpickers to orient a lock at 0, 45, 90, 135, 180, 225, 270, and 315 degrees. Print Settings Printer: GEEETECH A10 Rafts: No Supports: No Resolution: 200 Infill: 30% Filament: 3D…
This is SMARS remix designed to take the Smartibot controller and motor system whilst retaining the SMARS track system. It is still very much a work in progress as: the drive wheels need possibly a wee bit less taken out of the hub to…
A while back I subscribed to the Alien3D monthly filament box. Each box comes with a number of filament samples and a little card detailing it's properties. The problem I found was that the I kept forgetting which filament sample I was…
This holder has been designed to enable lockpickers to orient a lock at 0, 45, 90, 135, 180, 225, 270, and 315 degrees. It was designed to test if there is an orientation that locks pick best at. The build comprises of: 1 x Inner 1 x…
To wszystkie aktualnie dostępne wyniki.
