Liczymy pasujące modele…
Printed with PLA and three perimeters. Should snap right on to the main vacuum and then parts snap on after. If the snap is too tight, you can warm it with a hair dryer just a little and it will loosen up.
I made this handle because it was so awkward trying to vacuum with this thing normally. The male side is a bit tight, but it works. The other side is great. The handle is at 45 degrees and the hose is at 40 degrees because that's what I…
Made this cause I needed it. I probably should've added some better handles because it's a little tricky to get out but it works. The little lower ssd spot I put in but I haven't tested it at all.
To wszystkie aktualnie dostępne wyniki.
