Dewalt Stealthsonic Shop Vac Hose Handle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A handle for the shop vac hose
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 45
- Wydruki
- 0
- Wyświetlenia
- 224
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
I made this handle because it was so awkward trying to vacuum with this thing normally. The male side is a bit tight, but it works. The other side is great. The handle is at 45 degrees and the hose is at 40 degrees because that's what I measured from the other end. I printed it with a tiny bit of support because I was worried about it falling over. Overhangs on my printer are garbage, so you might get better quality than I did on the handle, but none of the overhangs are where you touch, so it's not uncomfortable. I printed it out of PLA and that's working great so far. It might be better to print it out of a hard tpu so it flexes a little, but the PLA is working so far.