Dewalt Stealthsonic Shop Vac Hose Handle
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A handle for the shop vac hose
- Rating
- 0 / 5
- Likes
- 7
- Downloads
- 48
- Makes
- 0
- Views
- 232
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial
I made this handle because it was so awkward trying to vacuum with this thing normally. The male side is a bit tight, but it works. The other side is great. The handle is at 45 degrees and the hose is at 40 degrees because that's what I measured from the other end. I printed it with a tiny bit of support because I was worried about it falling over. Overhangs on my printer are garbage, so you might get better quality than I did on the handle, but none of the overhangs are where you touch, so it's not uncomfortable. I printed it out of PLA and that's working great so far. It might be better to print it out of a hard tpu so it flexes a little, but the PLA is working so far.