Liczymy pasujące modele…
I wanted a case to hold the 7 key set to keep the keys easily accessible, and a key ring was not working. There is a standalone case to hold the 7 keys and 2-3 rubber rings. There is a tight fitting cover that works well if you have a…
I mixed the mount arm I liked with the case I liked for the Prusa MK3S and Raspberry Pi 4 to use with OctoPrint. I created a basic mesh case, one with a ribbon cable slot, a case for a 30mm fan, and a 30mm fan with ribbon cable slot. With…
I only had M2.5 screws on hand, so I adjusted the holes to be self threading. I used M2.5*8 screws that sit pretty flush to the front and back. Included versions of the top with no letters on the buttons, and one with letters baked in to…
The Core One has a crevice underneath the side panels where debris can collect. I created a wedge that fills this gap to prevent that. Included is a wedge with no magnet cutouts and a few variations for common magnet sizes. If you use the…
Swapped my EnXclosure to the official Prusa XL Enclosure, and needed a new mount for the ESP32 cam. I could not find anything for the ESP32 camera case . So I modified the Prusabot mount to work with the camera case. I used 2 M3x8 screws…
I wanted a cover/protector for the EP-133 so I can throw it in a bag for travel. I grabbed the official bag from TE, but it's a soft bag, so I made a cover to go along with it to protect the fader and knobs from crush damage. My design…
I saw a few remixes of this Noctua prototype inspired design and a comment on one about how models closer to the prototype had higher air speed than the Major Hardware https://www.thingiverse.com/thing:4911660 model. I printed…
Eurorack faceplate designed to fit in a Pelican 1300 case. The top slot is 4hp for many models of eurorack power options. The bottom is 44hp. The rails are part of the model, for better and for worse. The better means you don't have to…
Heart shaped box with a smile. There are two major versions of the box parts. One with small tabs that clip into place so the tops will stay put, and a version with no clips where the tops just rests on the body with a lip for alignment.…
I had some plates for another speaker and measured all the dimensions and replicated the cover plates. The first prototype I made had printed the inner pegs that the soft TPU or TPE bumpers go on, but they are 3.2mm and snap off easily,…
I saw several HEPA air scrubbers for IKEA Lack enclosures, but the issue that I kept running into was not being able to find the right fan or the right filter or the filters were not in stock. So I found available filters and a fan and…
I purchased a PCB holder and it had a max width of 9". That was too short for a project I'm working on, so I made this modular span replacement. The pieces are 30mm x 15mm x 120mm with an additional 10mm for the plug ends. There is only…
Cases for the Teenage Engineering CM-15, TP-7, and TX-6. I didn't find any small form factor cases that fit my needs. The cases and bags I found were either larger than I was looking for, or didn't provide enough protection if thrown in a…
To wszystkie aktualnie dostępne wyniki.
