Liczymy pasujące modele…
No shell cutting required, replaces the sliding doors at the bottom of the priming slide. Undo the four screws on the slide, pull out the doors, put in the T-pull, assemble again. Printing requires support for the tabs on the sides.
Scale as needed to make it take up most of your print surface. One corner cut to identify the front-right corner, to more easily find high spots and low spots after removing the print. You can get by printing one layer, but it can be…
3D printable piece, designed to work with the flywheel puller metal part made by Fetteworst, to pull any Daybreak, Kepler or Pulsar wheels (or any other wheels with the same top geometry) off a motor shaft, without risking bending the…
No shell cutting required, replaces the sliding doors at the bottom of the priming slide. Undo the four screws on the slide, pull out the doors, put in the T-pull, assemble again. Printing requires support for the tabs on the sides.
Slot furthest away is for cutting intact darts into shorter darts. Slot closest to the “wall” is for cutting foam by itself, for adding a dart head to afterwards.
Color changes at certain heights could be used to achieve a multi-color print with different colors in different areas of the face.
Jig for cutting 3 mm round stock - I used carbon fiber rods, but anything sufficiently rigid should work - to the right lengths to reinforce a Nerf N-Strike Recon shoulder stock. Cut four pieces at each length, total length of all the…
To wszystkie aktualnie dostępne wyniki.
